Plated Piping (Straight)
Plated piping is the lighter of the mod's two tiers, bursting above 2.5 atm and passing up to 50 L/s, enough to clear everything the iron tier runs, a fully loaded Tub Blast Machine included. It has no valve of its own tier; a valve or a pressure valve on a plated run is always a cast one, since both tiers bolt through the same flange. No plain cast segment has a recipe; the plated segments and the cast fittings do.

See Pipe networks and pressure.

front
right
back
left
topMade by
| Nails and strips (Iron) | Iron plate | Iron plate | Iron plate | Nails and strips (Iron) |
| Plated Piping (Straight) x 4 | ||||
Needs: 3 Iron plate, 2 Nails and strips (Iron); makes 4 Plated Piping (Straight)
| Rivets | Iron plate | Iron plate | Iron plate | Rivets |
| Plated Piping (Straight) x 4 | ||||
Needs: 3 Iron plate, 2 Rivets; makes 4 Plated Piping (Straight)
Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).
Used in
| any Hammer (tool, not consumed) | ||
| any Plated Piping (Straight) | Iron plate | any Plated Piping (Straight) |
| Nails and strips (Iron) x 2 | Iron plate | |
| Steam Condenser | ||
Needs: 2 any Plated Piping (Straight), 2 Iron plate, a Hammer (kept), 2 Nails and strips (Iron); makes 1 Steam Condenser
Crafting chain
- An iron ingot is smithed into a plate at the anvil.
- Nails and Strips come from the anvil or the Nail Machine; Rivets from the Rivet Heading Machine take their place.
- The Plated Pipe Diagram goes in the Vice Bench's diagram slot, and plates and fasteners in the crafting grid in the segment's pattern; a hammer held on the bench works the step, which gives the Plated Piping (Straight).