Fluid Intake

Draws fresh water into the pipe network.

The intake needs a full cube of water at least three blocks deep directly beneath it, and it stops drawing if another intake sits within six blocks of another one, which is closer than it looks over a small pond. It draws on its own once a pump downstream is pulling from it; nothing about it needs a network already at pressure.

See Steam and boilers.

Fluid Intake, isometric
Fluid Intake, from the northnorthFluid Intake, from the easteastFluid Intake, from the southsouthFluid Intake, from the westwestFluid Intake, the top (up)top
Fluid Intake, isometric.

Made by

any Hammer (tool, not consumed)
Iron plateany Plated Piping (Straight)Iron plate
Nails and strips (Iron) x 2Iron plateNails and strips (Iron) x 2
Fluid Intake

Needs: 1 any Plated Piping (Straight), 3 Iron plate, 4 Nails and strips (Iron), a Hammer (kept); makes 1 Fluid Intake

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).

Crafting chain

  1. A plated straight is made as in the plated piping chain: plate, a fastener and a hammer in the crafting grid.
  2. The plated straight, plates, nails and a hammer go into the crafting grid, which gives the Fluid Intake.