Cast Iron Shaft

A shaft segment adds a little rotating mass of its own to whatever line it sits on, so a run of them rides jitter better without a dedicated flywheel to smooth it out. It runs north-south, east-west or straight up and down; a machine takes its drive from the two faces along its own shaft's axis.

A shaft standing on a solid floor is meant to show a support bearing there, the way vanilla's axle does against a wall.

A shaft segment, iso
A shaft segment

See Shaft power and the flywheel.

Cast Iron Shaft, isometric
Cast Iron Shaft, from the northnorthCast Iron Shaft, from the easteastCast Iron Shaft, from the southsouthCast Iron Shaft, from the westwestCast Iron Shaft, the top (up)top
Cast Iron Shaft, isometric.

Made by

Cast Shaft Blank
Cast Iron Shaft

Needs: 1 Cast Shaft Blank; makes 1 Cast Iron Shaft

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).

Crafting chain

  1. Pig iron and coke or charcoal go into the Cupola Furnace and come out as molten cast iron.
  2. The molten iron is poured in a Small Flask with the shaft pattern, which gives the Cast Shaft Blank.
  3. The blank is seated in the face vice of the Vice Bench and worked in four steps: a chisel with a hammer in the other hand, a file with rendered fat, the chisel and hammer again, and a hammer with a cast iron ingot in the other hand. The fat and the ingot are used up. The shaft comes out with a bit of cast iron.

The shaft is no longer made from rod, plate and a hammer.