Small Flask
Ram Green Sand into the flask once, which is never taken back out, then press a Pattern into it to raise the impression; the pattern takes a point of damage for the privilege. Let the run fill it through the launder face, wait for the cast to harden, then take it out empty-handed to shake the part free and rake the sand back to full for the next pour.
A pour that arrives too cool, or runs short, hands back scrap instead of the part. See Molten metal and casting.


front
right
back
left
topMade by
| any Board | any Board | |||
| any Board | Nails and strips (Iron) | any Board | ||
| any Sand | Fire clay | |||
| Small Flask | ||||
Needs: 1 Fire clay, 4 any Board, 1 Nails and strips (Iron), 1 any Sand; makes 1 Small Flask
Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).
Crafting chain
- Sand and blue clay go into the crafting grid, eight sand and one clay to eight Green Sand.
- A Flask Diagram is drafted at the Drawing Table. At the Vice Bench it goes in the bench's diagram slot, with four planks, a bundle of nails and strips, a sand and a fire clay laid in the crafting grid in the small flask's pattern; a hammer held on the bench works the step, which gives the Small Flask, a plank box strapped with wrought iron.
- A pattern is drafted as a diagram at the Drawing Table and cut with a knife from pattern boards; it is pressed into the Green Sand rammed into the placed flask.
Tested setup: chequer plates in the floor flask
The Floor Flask is a larger flask placed with the same Flask Diagram, and it works the same ram, press, pour and shake cycle. The mod's tests make one and cast an iron floor with it, the way a player would.
- Bolts and Nuts are made in the crafting grid from Bolt Blanks and an iron Screw Plate.
- A Drawing Table and a Vice Bench are placed and built.
- The Flask Diagram is drafted at the Drawing Table from charcoal and parchment.
- The Floor Flask stands in a 2 x 2 pit dug in granite, at the end of a canal: a Molten Canal (Start) and two straight pieces. The setup places the flask and raises it by the construction; a player aims the Flask Diagram at the pit instead, with sand in the other hand, which the Flask Pit Aim setup proves.
- The Cast Plate Diagram is drafted, and the bench cuts the Chequer Plates Pattern from it with a knife and two pattern boards.
- Eight sand and a blue clay make Green Sand, which is rammed into the flask once.
- The pattern is pressed into the sand three times, once for each plate.
- Molten pig iron, 100 units at 1250 C, enters the start every 4 seconds. The three plate cavities fill to 900 units and take no more.
- Time moves on an hour at a time until the iron is hard, and an empty hand shakes out 3 Chequer Plates. The flask is left as bare sand, its impression gone.
- At the bench, two of the plates with 2 fire bricks, 1 mortar, the bolts and a hammer make a Chequer-Plate Floor, which is placed.
The charcoal, parchment, fire bricks, mortar, planks, sand, blue clay, hammer, chisel and knife are gathered as in play. The Drawing Table, the Vice Bench and the canal are placed rather than crafted, with the tables' building materials supplied; the Bolt Blanks and the Screw Plate are handed over because the tests do not make them yet, and the iron is poured straight into the start in place of a furnace tapping into it.



