Molten Canal (Slope)

A graded canal piece that carries metal down; nine make a block's fall.

The piece that carries molten metal down to a lower floor. A level canal only levels, so it cannot lower a pour; a slope runs it downhill and stands empty once the pour has passed.

A slope runner is ten pieces in a straight line. Set a slope against the open end of a level canal, then set each next slope against the last. Each one takes its own step, a little lower than the one before, and the game turns it to face the run. Nine slopes fall most of a block. The tenth slope you place becomes the Molten Canal (Slope Drop), so stand a Molten Canal (Start) one block down first, directly under where the tenth will go. A straight, bend, tee, cross, tap or another slope then carries on from that start.

Bricks of any colour or fire brick make a slope, and which you use changes nothing about how it carries metal. See Molten metal and casting.

Molten Canal (Slope), isometric
Molten Canal (Slope), the front (south)frontMolten Canal (Slope), the right (east)rightMolten Canal (Slope), the back (north)backMolten Canal (Slope), the left (west)leftMolten Canal (Slope), the top (up)top
Molten Canal (Slope), drawn from the front, which faces south.

Made by

Molten Canal (Slope), with bricks
Mortar
any Brick x 2
Fire clay x 4
Molten Canal (Slope) x 2

Needs: 2 any Brick, 1 Mortar, 4 Fire clay; makes 2 Molten Canal (Slope)

Molten Canal (Slope), with fireclay bricks
Mortar
Fireclay brick x 2
Fire clay x 4
Molten Canal (Slope) x 2

Needs: 2 Fireclay brick, 1 Mortar, 4 Fire clay; makes 2 Molten Canal (Slope)

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).

Crafting chain

  1. Fire clay is dug. 2 bricks of one colour, or 2 fire bricks, and 1 mortar supply the masonry.
  2. A Diagram of the Molten Canal is drafted at the Drawing Table. At the Vice Bench it goes in the bench's diagram slot.
  3. In the 5 by 5 grid, lay the bricks in the centre cell, the mortar in the cell above it, and 4 fire clay in the cell one below and one to the right of the centre. The Craft button makes 2 slopes.

A whole runner of ten is five crafts: 10 bricks, 5 mortar and 20 fire clay.

What goes wrong

"A slope must be set against the open end of a canal or the outlet of another slope." There is nothing to continue there. Aim at a level canal with an open end, or at the low end of the last slope.

"The tenth piece of a slope runner needs a canal start one block down." Nine slopes are down and the next is the drop. Place the Molten Canal (Start) under that cell first.

"Nothing but a slope can be set against the outlet of a slope." A straight, bend or other canal piece cannot join the low end of a slope, and a slope cannot be set so that its low end meets a level canal. Carry on with slopes until the drop.

A Canal Plate will not go in. A slope cannot be plated. Plate the level cell before it.

A wrench does nothing. A slope keeps the direction it was placed with. To change it, break the piece and place it again.