Rolling Mill

The mill reduces stock and nothing else: fit a roll set by right-clicking it into the machine, lay stock on the input deck, and right-click the near or the far side of the piece to choose which side goes through. On the flat and grooved sets, where along the deck the click lands picks the gap, since the deck is split into one band per gap the set carries. The wide set has no bands: its top roller is screwed. Hold right click on the cell above either end of the stand to lower the top roller a step every 0.4 seconds, down to a 1.0 gap, and hold right click while sneaking to raise it, up to 2.5. The roller's height shows the gap, block info reads it, and it cannot move while stock is under the rolls. The wide set feeds only the rung equal to the gap you set: a gap at or above the piece's thickness gives "no reduction", and a gap that is no rung of its route, or too deep a bite, will not bite. It never finishes a piece; everything it thins goes on to the Shearing Machine.

See Rolling and the forming shop for the schedule the rolls will actually bite.

Rolling Mill, isometric
Rolling Mill, from the northnorthRolling Mill, from the easteastRolling Mill, from the southsouthRolling Mill, from the westwestRolling Mill, the top (up)top
Rolling Mill, isometric.

Made by

Heavy Cast PlateIron rod x 2Heavy Cast Plate
Heavy Cast PlateSpur GearHeavy Cast Plate
Heavy Cast Plateany Hammer (tool, not consumed)Heavy Cast Plate
Rolling Mill

Needs: 6 Heavy Cast Plate, 2 Iron rod, 1 Spur Gear, a Hammer (kept); makes 1 Rolling Mill

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).