Piping (Bend)

A 90 degree bend in a pipe run.

It is one of the four shapes that take part in over-pressure failure: the weakest plain pipe on a run, this one included, sets the burst rating for the whole thing, 5 atm for iron and 10 for steel, so one iron bend in an otherwise steel line caps it.

A wrench cycles only the orientations valid in the cell it sits in. Where only one is valid it will not turn at all: break it, place the neighbour that decides its shape, and place it again.

frontrightbacklefttop

Made by

	any Hammer (tool, not consumed)
Nails and strips (Iron or Steel)	Plate (Iron or Steel)
	Nails and strips (Iron or Steel)
Piping (Bend)

Needs: 1 Plate (Iron or Steel), 2 Nails and strips (Iron or Steel), a Hammer (kept); makes 1 Piping (Bend)

Amounts are the mod's defaults; the recipe-cost level changes them (see Commands and config).