Iron Tap

The lower tap-hole, at the crucible floor. Drains the hearth's molten iron into a canal below, and the slag after it once the iron is gone.

A newly built tap comes plugged. Break the plug out with an empty hand, then hold a flame against the open tap to blow the furnace in; four fire clay held against it stops the tap again. Breaking the plug refunds nothing, so lighting a furnace this way costs one clay plug every time it is done.

An open iron tap drains the iron from the bottom of the pool and then the slag above it, so plug it before the slag reaches the moulds. Put a canal start under the spout first, or accept chiselling the metal out where it solidifies at the mouth. See Furnaces and heat and Molten metal and casting.

The iron tap, iso
The iron tap
Iron Tap, isometric
Iron Tap, the front (south)frontIron Tap, the right (east)rightIron Tap, the back (north)backIron Tap, the left (west)leftIron Tap, the top (up)top
Iron Tap, drawn from the front, which faces south.

Made by

Refractory brick (Tier 3) x 2Iron plateany Hammer (tool, not consumed)
Refractory brick (Tier 3) x 2Fire clay x 12any Chisel (tool, not consumed)
Refractory brick (Tier 3) x 2Refractory brick (Tier 3) x 2Refractory brick (Tier 3) x 2
Iron Tap

Needs: 10 Refractory brick (Tier 3), 12 Fire clay, 1 Iron plate, a Hammer (kept), a Chisel (kept); makes 1 Iron Tap

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).

Crafting chain

  1. Fire clay is dug, an iron plate is forged at the anvil, tier 3 fired refractory bricks are gathered, and a hammer and a chisel are held ready.
  2. In the crafting grid they make the Iron Tap.
  3. The tap is set low in the hearth wall of a Cold Blast Furnace or a Cupola Furnace, over a canal start, and it comes plugged.