Bessemer Gas Intake

The converter's air intake.

The Bessemer Gas Intake is the converter's air port, and it has to face the same way as the Bessemer Control: any other orientation completes the structure and then refuses to run, with "Gas intake misaligned!" on the panel. It is a fixed port rather than a pipe node, so a pipe has to sit in the cell in front of it, presenting a connector back at it. See Bessemer process for the 2.5 atm gate it has to clear before the vessel does anything at all.

frontrightbacklefttop

Made by

any Hammer (tool, not consumed)	Plate (Iron or Steel) x 4
any Piping (Straight)	Plate (Iron or Steel) x 4	Plate (Iron or Steel) x 4
Rod (Iron or Steel) x 16	Nails and strips (Iron or Steel) x 8
Bessemer Gas Intake

Needs: 16 Rod (Iron or Steel), 12 Plate (Iron or Steel), a Hammer (kept), 8 Nails and strips (Iron or Steel), 1 any Piping (Straight); makes 1 Bessemer Gas Intake

Amounts are the mod's defaults; the recipe-cost level changes them (see Commands and config).