Drag Cross Bar
A cast-iron bar bolted across the long flask drag. Four go in a drag.
The long flask's drag is cast iron on a bed of sand, built from six kinds of casting, sixteen pieces in all. Each casting holds only the iron its pour makes, with no bolts or holes. How the drag is built up is on the Long Flask page.

The castings
Every pattern for them is carved from the Long Flask Drag Diagram. Units are per piece.
| Casting | Units | A drag takes | Where it is poured |
|---|---|---|---|
| Drag Side Section | 358 | 6 | Floor Flask, 1 to a pour |
| Drag Left Corner | 409 | 2 | Floor Flask, 1 to a pour |
| Drag Right Corner | 409 | 2 | Floor Flask, 1 to a pour |
| Drag North End | 482 | 1 | Floor Flask, 1 to a pour |
| Drag South End (notched for the pouring box) | 367 | 1 | Floor Flask, 1 to a pour |
| Drag Cross Bar | 63 | 4 | Floor Flask, 3 to a pour |
One drag is 4885 units of cast iron. Building it also takes 6 bolts and 2 wedge strips.
Crafting chain
- At the Drawing Table 1 medium and 1 parchment are drafted into the Long Flask Drag Diagram.
- At the Vice Bench the diagram goes in the bench's diagram slot and two pattern boards in the crafting grid, in the cells that pick the part; the knife held on the bench carves that part's Pattern in 2 strokes.
- Pig iron and coke or charcoal go into the Cupola Furnace and come out as molten cast iron.
- Each pattern is pressed into the green sand of a Floor Flask and the molten iron poured at 1150 C or hotter gives the castings.
- With the castings, the bolts and the wedge strips in the inventory, the drag is built up on the placed long flask.