Cope Cross Bar Casting

A cast-iron bar that crosses the long flask cope to hold its sand. Four go in a cope.

The long flask's cope, the cast-iron lid that lets it pour closed patterns, is bolted together from eight kinds of casting, twelve pieces in all. Each casting holds only the iron its pour makes, with no bolts or holes. How the cope is hung and worked is on the Long Flask page.

The cope on the long flask, swinging shut on its hinges, isoThe cope on the long flask, swinging shut on its hinges, closed cycle
The cope on the long flask, swinging shut on its hinges
Cope Cross Bar Casting, isometric
Cope Cross Bar Casting.

The castings

Every pattern for them is carved from the Long Flask Cope Diagram. Units are per piece.

CastingUnitsA cope takesWhere it is poured
Cope East Side Half Casting (hinge knuckle cast on)6052Long Flask, 2 to a pour
Cope West Side Half Casting (cramp lug cast on)6101Long Flask, 2 to a pour
Cope Staple Side Half Casting (cramp lug and lifting staple)6101Long Flask, 2 to a pour
Cope North End Casting4901Floor Flask, 1 to a pour; Long Flask, 2
Cope South End Casting (notched for the pouring box)3851Floor Flask, 1 to a pour; Long Flask, 2
Cope Cross Bar Casting1253Floor Flask, 1 to a pour; Long Flask, 4
Cope Hinge Leaf Casting122Floor Flask, 2 to a pour; Long Flask, 4
Cope Anchor Plate Casting42Floor Flask, 2 to a pour; Long Flask, 4

One cope is 3712 units of cast iron. Hanging it also takes 8 bolts, two on each hinge leaf and two on each anchor plate, and 4 iron rods, a pin for each hinge leaf and a wedge for each cramp.

Crafting chain

  1. At the Drawing Table 1 medium and 1 parchment are drafted into the Long Flask Cope Diagram.
  2. At the Vice Bench the diagram goes in the bench's diagram slot and two pattern boards in the crafting grid, in the cells that pick the part; the knife held on the bench carves that part's Pattern in 2 strokes.
  3. Pig iron and coke or charcoal go into the Cupola Furnace and come out as molten cast iron.
  4. Each pattern is pressed into the green sand of a Long Flask, or of a Floor Flask for the parts it takes, and the molten iron poured at 1150 C or hotter gives the castings.
  5. With every casting, the bolts and the rods in the inventory, the cope is hung on the built long flask.