Ratchet Brace

The Ratchet Brace is the hand drill of the Vice Bench: a lever with a pawl that turns a ratchet wheel on the spindle, a flat bit in the spindle's square socket, and a feed screw with a centre point that carries the pressure. Held in the active hand, it works the drilling steps of a bench recipe. Each finished step costs it one point of durability, 120 for the iron brace and 300 for the steel one, and it is gone when none is left. The iron and the steel brace differ only in the bit; the rest of the body is forged iron.

The ratchet brace: bit, socket and ratchet wheel on the spindle, the forked lever with its pawl, and the feed nut under the centre point, iso
The ratchet brace: bit, socket and ratchet wheel on the spindle, the forked lever with its pawl, and the feed nut under the centre point
Ratchet Brace, isometric
Ratchet Brace.

Made by

Ratchet Brace Feed Screw
Ratchet Brace LeverRatchet Brace SpindleNails and strips (Iron)
any Ratchet Brace Bit
any Ratchet Brace; the Ratchet Brace Bit decides which

Needs: 1 Ratchet Brace Feed Screw, 1 Ratchet Brace Lever, 1 Ratchet Brace Spindle, 1 Nails and strips (Iron), 1 any Ratchet Brace Bit; makes 1 any Ratchet Brace

Amounts are the mod's defaults; the recipe-cost level changes them (see recipe cost levels).

Drilling at the Vice Bench

A drilling step plays the firestarter's to-and-fro and its drilling sound, one stroke every 2 seconds, so a step of 3 strokes takes 6 seconds of work. Letting go keeps the strokes already finished and loses only the one under way. The one drilling step in the game so far is the lugs of a Cast Ladle Bowl for its shank, 3 strokes.

Crafting chain

  1. At the anvil, one iron ingot each is smithed into the Ratchet Brace Lever, the Ratchet Brace Spindle and the Ratchet Brace Feed Screw.
  2. The bit is smithed from one ingot as well: iron for the Ratchet Brace Bit - Iron, steel or crucible steel for the Ratchet Brace Bit - Steel.
  3. At the Vice Bench the feed screw goes above the spindle, the bit below it, the lever to its left and one iron nails and strips to its right. The bench then asks for three steps of 2 strokes each: the file dresses the ratchet's teeth and the pawl, the hammer rivets the pawl's pin through the fork, and bare hands run the feed screw into the spindle and seat the bit. The bit's metal decides whether an iron or a steel brace comes out.